FSC-8030: Preservative and Sealing Compounds

Documents

• A-A-1500 – SEALER SURFACE (LATEX BLOCK FILLER) (NO S/S DOCUMENT)
• A-A-1556 – SEALING COMPOUND (ELASTOMERIC JOINT SEALANTS) (S/S BY ASTM-C920)
• A-A-2210 – FILLER, WOOD, PASTE (NO S/S DOCUMENT)
• A-A-2542 – SEALER, TERRAZO AND CONCRETE FLOORS, WATERBASED (NO S/S DOCUMENT)
• A-A-2702 – Sealing Compound (Liquid Protectant and "Beautifier")
• A-A-272 – Caulking Compounds
• A-A-2817 – Tire Puncture Sealant and Inflator (No S/S Document)
• A-A-2884 – Neat's-Foot Oil (No S/S Document)
• A-A-2982 – Coating Compound, Butuminous, Fillers, Solvent Type, Aluminum Pigmented (No S/S Document)
• A-A-3110 – Plumbing Fixture Setting Compound (No S/S Document)
• A-A-3133 – Filler, Two Component Type (for Dents, Cracks, Small Holes, and Blow Holes) (No S/S Document)
• A-A-373 – GLAZING COMPOUND, SASH (METAL) FOR BACK BEDDING AND FACE GLAZING (NOT FOR CHANNEL OR STOP GLAZING) (S/S BY ASTM-C669)
• A-A-378 – PUTTY, LINSEED OIL TYPE, (FOR WOOD SASH GLAZING) (NO S/S DOCUMENT)
• A-A-52408 – Preservative Coating, Rubber: for Rubber Surfaces
• A-A-52495 – Sealing Compound, Non-Curing, Polybutene
• A-A-56025 – Paste, Conductive
• A-A-58092 – Tape, Antiseize, Polytetrafluorethylene
• A-A-59258 – Tape, Aluminum Foil, Heat Reflective, Pressure Sensitive Adhesive
• A-A-59276 – Wood Preservatives: Waterborne or Water Reducible
• A-A-59293 – Sealing Compound, Adhesive: Curing (Polysulfide Base)
• A-A-59295 – Corrosion Preventive Compounds, Cold Application, for New and Fielded Motor Vehicles and Trailers and Protection of Steel Enclosed Spaces
• A-A-59313 – Thread, Compound; Antiseize, Zinc Dust-Petrolatum
• A-A-59464 – Plastic Plastisol (for Coating Metallic Objects)
• A-A-59491 – Sealing Compound, Thread and Gasket, Hydrocarbon Fluid and Water Resistant
• A-A-59719 – 100% Polyurethane Sprayed on Linings (S/S by MIL-PRF-32440)
• A-A-59720 – Sealing and Locking Compounds, Single-Component
• A-A-59885 – Corrosion Prevention Compound (CPC)
• ANSI-SAE-Z26.1 – Safety Glazing Materials for Glazing Motor Vehicles and Motor Vehicle Equipment Operating on Land Highways
• ASTM-C1085 – SEALANTS, BUTYL RUBBER-BASED SOLVENT-RELEASE (NO S/S DOCUMENT)
• ASTM-C570 – OIL- AND RESIN-BASE CAULKING COMPOUND FOR BUILDING CONSTRUCTION (NO S/S DOCUMENT)
• ASTM-C603 – Sealants, Elastomeric, Extrusion Rate and Application Life of
• ASTM-C639 – Sealants, Elastomeric, Rheological (Flow) Properties of
• ASTM-C661 – Sealants by Means of a Durometer, Elastomeric-Type, Indentation Hardness of
• ASTM-C669 – METAL SASH, GLAZING COMPOUNDS FOR BACK BEDDING AND FACE GLAZING OF (NO S/S DOCUMENT)
• ASTM-C679 – Sealants, Elastomeric, Tack-Free Time of
• ASTM-C719 – Sealants, Elastomeric Joint, Under Cyclic Movement (Hockman Cycle). Adhesion and Cohesion of
• ASTM-C732 – Sealants, Latex, Artificial Weathering on, Aging Effects of
• ASTM-C792 – Sealants, Elastomeric, Effects of Heat Aging of Weight Loss, Cracking, and Chalking of
• ASTM-C793 – Sealants, Elastomeric Joint, Effects of Laboratory Accelerated Weathering on
• ASTM-C794 – Sealants, Joint, Elastomeric, Adhesion-in-Peel, Test Method for
• ASTM-C834 – Latex Sealants
• ASTM-C920 – Sealants, Elastomeric Joint
• ASTM-D1190 – SEALER, CONCRETE JOINT, HOT-APPLIED ELASTIC TYPE (NO S/S DOCUMENT)
• ASTM-D1272 – Pentachlorophenol (No S/S Document)
• ASTM-D1625 – Arsenate, Chromated Copper (No S/S Document)
• ASTM-D1858 – CREOSOTE PETROLEUM SOLUTION (NO S/S DOCUMENT)
• ASTM-D2824-D2824M – Aluminum-Pigmented Asphalt Roof Coatings, Nonfibered, and Fibered without Asbestos
• ASTM-D2825 – ASPHALT ROOF COATINGS, ALUMINUM PIGMENTED (S/S BY ASTM D2824-82)
• ASTM-D391 – Creosote-Coal Tar Solution, Standard Specification for (No S/S Document)
• ASTM-D453 – Acids, Tar, in Cresote-Coal Tar Solutions, Standard Test Method for (No S/S Document)
• ASTM-D4562 – Adhesives Using Pin-and-Collar Specimen, Shear Strength of
• ASTM-D5363 – Anaerobic Single-Component Adhesives (AN)
• ASTM-E759-E759M – Standard Test Method for Effect of Deflection on Sprayed Fire-Resistive Material Applied to Structural Members
• AWPA-A1 – Creosote & Oil-Type Preservatives, Standard Methods for Analysis
• AWPA-A11 – Treated Wood & Treating Solutions by Atomic Absorption Spectroscopy
• AWPA-A2 – PRESERVATIVES, WATERBORNE, & FIRE RETARDANT FORMULATIONS, STANDARD METHODS FOR ANALYSIS OF
• AWPA-A3 – PENETRATION OF PRESERVATIVES & FIRE RETARDANTS, STANDARD METHODS FOR DETERMINING
• AWPA-A4 – Wood Preservatives, Standard Methods for
• AWPA-A5 – PRESERVATIVES, OIL-BORNE, ANALYSIS OF, STANDARD METHODS FOR
• AWPA-A6 – Wood, Oil-Type Preservatives & Water in, Method for the Determination of
• AWPA-A7 – WOOD, PREPARING, FOR CHEMICAL ANALYSIS, STANDARD WET ASHING PROCEDURE FOR
• AWPA-A8 – Creosote or Creosote-Coal Tar Solution from Freshly Treated Piles, Poles, or Timber (Squeeze Method) Qualitative Recover of (No S/S Document)
• AWPA-A9 – WOOD, TREATED, & TREATING SOLUTIONS BY X-RAY SPECTROSCOPY, STANDARD METHOD FOR ANALYSIS OF
• AWPA-F1 – Creosote-Coal Tar Solution (up to 50 Percent Tar) and Coal Tar (Coke Oven Tar) Volume and Specific Gravity Correction Tables for Creosote (No S/S Document)
• AWPA-F4 – Creosote-Petroleum Solutions, Standard Volume Correction Table for (No S/S Document)
• AWPA-F5 – Salt Solutions, Preservative, Volume Correction Factors for (No S/S Document)
• AWPA-F6 – Factors and Correction Tables, Miscellaneous Conversion (No S/S Document)
• AWPA-M4 – Standard for the Handling, Storage, Field Fabrication and Field Treatment of Preservative-Treated Wood Products
• AWPA-P11 – Creosote-Pentachcorophenol Wood Preservative Solution, Standard for (No S/S Document)
• AWPA-P12 – Creosote-Coal Tar Solution to be used in the Treatment of Marine (Costal Waters) Piles and Timbers, Standard for (No S/S Document)
• AWPA-P2 – CREOSOTE & CREOSOTE SOLUTIONS, STANDARD FOR
• AWPA-P3 – OIL SOLUTION, CREOSOTE-PETROLEUM, STANDARD FOR
• AWPA-P4 – Creosote, Petroleum Oil for Blending with, Standard for
• AWPA-P5 – Preservative, Waterborne, Standards for
• AWPA-P7 – Field Cuts, Creosote for Brush or Spray Treatment, Standard for (No S/S Document)
• AWPA-P8 – Standard for Oil-Borne Preservative
• AWPA-P9 – SOLVENTS & FORMULATION FOR ORGANIC PRESERVATIVE SYSTEMS, STANDARD FOR
• C-N-200 – NEATS FOOT OIL (S/S BY A-A-2884)
• DOD-C-2687 – Compound, Battery-Sealing (METRIC) (No S/S Document)
• DOD-R-18708 – RUST-ARRESTING COATING, SHIPBOARD EXTERIOR, GRAY, NAVY FORMULA NO. 123G METRIC (NO S/S DOCUMENT)
• DOD-S-82708 – SEALING COMPOUND, PREFORMED (METRIC)
• DOD-STD-1371 – INSPECTION PROCEDURE FOR USE OF ANAEROBIC THREAD LOCKING COMPOUNDS WITH STUDS (S/S BY SAE-J2270)
• FED-STD-293 – TAPE, PRESSURE SENSITIVE ADHESIVE (FSC 8030)
• HH-C-536 – COMPOUND, PLUMBING-FIXTURE-SETTING (NO S/S DOCUMENT)
• HH-T-30 – TAPE, PIPE COATING, COAL TAR, HOT APPLIED, AND PRIMER
• JAN-A-669 – ANTI-SEIZE-COMPOUND, WHITE-LEAD-BASE, GENERAL-PURPOSE (FOR THREADED FITTINGS) (USE TT-A-580)
• JAN-C-168 – Compound, Calking (for Wooden Vessels) (S/S by MIL-C-18969)
• JAN-C-238 – Coating, Exterior, Camouflage and Rust-Inhibiting (for Processed and Nonprocessed Food Cans)
• JAN-C-693 – CEMENT, METALLURGICAL, AIR-SETTING, HIGH TEMPERATURE
• JAN-P-115 – PACKAGING AND PACKING FOR OVERSEAS SHIPMENT - COMPOUND, SEALING, DIPCOATING
• JAN-P-604 – PROTECTIVE COATING SYSTEM, PHONOLIC RESIN BASE, HEAT&HARDENING &FOR THE INTERIORS OF POTABLE&WATER TANKS&
• L-T-1512 – Tape, Pressure Sensitive Adhesive, Pipe Wrapping (No S/S Document)
• L-T-80 – Tape, Pressure-Sensitive Adhesive (Aluminum-Backed)
• MIL-A-12352 – Antiseize Compound, Threads, for Steam and Water Lines (Use TT-S-1732)
• MIL-A-13881 – Anti-Seize Compound, Mica-Base (for Threaded Fittings) (No S/S Document)
• MIL-A-38267 – Application of Polyurethane Fuel Tank Coatings (No S/S Document)
• MIL-B-12121 – Plastic, Coating Compound, Strippable (Sprayable)
• MIL-C-0083933/(the base document for this interim revision is MIL-C-83933 NOT 2) – Corrosion Preventive Compound, Cold-Application (for Motor Vehicles) (No S/S Document)
• MIL-C-102 – Coating Compound, Bituminous, Solvent Cut Back, Box and Crate Topcoating
• MIL-C-10382 – Corrosion Preventive, Petrolatum, Spraying Application: for Food Handling Machinery and Equipment